Think Beyond the Big Box...

Showing Posts Tagged: floor cleaning

Refresh the Carpets


Carpeted areas can be some of your highest traffic areas. Did you know you can use the power of Original Pine-Sol® Multi-Surface Cleaner to remove that stubborn carpet or rug stain? It also leaves your entire room smelling fresher and looking brighter.

For spot treating, rub in a splash of full-strength Original Pine-Sol® Multi-Surface Cleaner on grease spots or heavy dirt marks with a sponge or cleaning brush. Then, wipe or rub plain water on the spot and dry thoroughly.

For a more all-around cleaning and deodorizing, you can apply this same process across your entire carpet. If you have area rugs, they can be cleaned In Your Washer with Pine-Sol®cleaner. You may also be able to use Original Pine-Sol® Multi-Purpose Cleaner in your steam cleaner, though you should check with the instructions for your device first.

If you’re not sure your carpet is colorfast, be sure to test an inconspicuous area first. And remember to avoid using scented Pine-Sol® varieties on fabrics, laundry or carpets.


All Floor Pads are Not Created Equal!

All the information you need on floor pads for your office equpiment cleaning supplies is here! Floor pads are a cost effective way to product beautiful looking floors. Each pad is designed to perform a specific job and to provide consistent performance while assuring high-quality reproducible results.

The differences between floor pads may seem small, but when added up, they can make a big difference to your bottom line in terms of produtivity and labor costs. 3M floor pads offer:

                        – Uniform distribution of mineral abraisves throughout the pad (not just on                                   the surface) assures superior performance and long, useful life.

                       – Individually separated and coasted fibers help produce better, more consistent results.

                      – The right amount of aggresiveness for every type of stripping, scrubbing and cleaning job.

                       – Each floor pad is engineered specifically for a particular maintenance task



STRIP– to remove all finish, sealer and contaminants from the floor surface. Done at the start of a maintenance program and at times when scrubbing will not acheive the desired result. Click here for stripping pads

SCRUB– Done prior to replacing worn finish; provides a fresh new surface to maintain. Click here for scrubbing pads

BUFF/POLISH– Buff very soft finishes or use polishing soft waves on wood floors. Polish to remove light soil and other contaminants. Click here for buffer pads and click here for polishing pads